Dentemp® Recap-It

Dentemp Recap-it Cap and Crown Repair is a unique, no-mix cement made especially for replacing loose caps and crowns. Tested, safe, and effective.

Read the Directions carefully before using. Keep out of reach of children.

CAUTION:

This product should not be used if throbbing pain or swelling in the affected area exists. Consult your dentist immediately. This product is sold as a temporary remedy. See your dentist as soon as possible for permanent work to be performed. Failure to do so may cause infection and/or serious injury. Store at room temperature with the tube closed to keep the material soft. Lot code on the container.

DIRECTIONS:

Wash hands. Prepare the crown by carefully removing as much old cement as possible from inside the crown. Rinse well. Clean and rinse the tooth area with water and leave it moist. Fit the crown back on the tooth before applying the new material. Make sure it fits properly. If you cannot do this, DO NOT PROCEED. See your dentist. Make sure the inside of the crown is dry. Open the tube by reversing the cap and punching a hole in the tip of the tube. Apply a small amount of material onto the upper inside edge of the crown. Remoisten the tooth area, place the crown on the wet tooth, and press firmly. Bite down several times to ensure a proper fit. If the bite is not completely comfortable, remove and repeat all steps until the crown feels normal. WAIT 5 MINUTES AND THEN GENTLY REMOVE ANY EXCESS MATERIAL. RINSE OUT MOUTH WELL WITH WATER. Allow at least 1 hour to set before eating. Cement will be fully set in 1 to 3 hours. NOTE: When replacing a bridge, apply material sparingly to only 1 hollow tooth at each end of the bridge. Dentemp Recap-it Cap and Crown Repair should not be used on implants or posts without the dentist’s advice.